Attaching & removing blade
Insert blade by rotating and pushing until flush against LED module. Use blade retention key to tighten (3) set screws.
Ensure that each set screw is securely fastened before attempting to use the saber.
Charging saber battery
Unscrew pommel and remove battery from hilt using battery pull tab. Unplug battery by grasping both ends of quick disconnect connectors (do not pull directly on wires). Green light on battery charging unit indicates battery is fully charged. Ensure that pommel is securely fastened with o-ring intact before attempting to use the saber.
L.E.D. swapping
DO NOT ATTEMPT TO REMOVE LED UNLESS SABER WAS PURCHASED DIRECTLY THROUGH KICKSTARTER OR FLOWSABER.COM
Loosen set screws and remove blade. Rotate saber, pommel facing up and shake until LED module passes through saber. Unplug LED by grasping both ends of quick disconnect connectors (do not pull directly on wires). Ensure that LED module is flush inside saber before tightening set screws.
FAILURE TO FOLLOW THESE INSTRUCTIONS OR ANY IMPROPER USE OF SABER MAY RESULT IN SERIOUS PHYSICAL INJURY.
PROTECTIVE GEAR IS REQUIRED WHEN SPARRING WITH FLOWSABER.
​
Taking proper care of your saber
Flowsaber is designed to resist high-impact drops with it's anodized aluminum body, however we recommend that you always train on soft surfaces like grass in order to prevent any unnecessary cosmetic damage. Over time your saber may accumulate some minor battle scars.. but that just adds character!
